Call Toll Free: 800-638-3880

Free Shipping on most orders over $200

Order over $200 of eligible merchandise and receive free shipping subject to the following conditions.  Free shipping offer applies to orders in which the cost of shipping is calculated to be 15% or less of the value of items ordered.  If the cost of shipping is calculated to be over 15% of the value of items ordered (based on item weights and shipping destination) then some charges will apply.  Free shipping offer is for Ground or Mail service within the continental United States, does not apply to bulk (third-tier priced) items, RJ items, and cannot be combined with other offers or discounts.  Customers outside of the United States ordering over $200 of eligible merchandise will receive a freight allowance of 15% of their order value to reduce their freight charges. Please email [email protected] or call us at (800) 638-3880 with questions.

Spoon Rest Aluminum Puck

More Views

Spoon Rest Aluminum Puck

Product Description

This aluminum puck is 2.625" across at the widest area and 3.375" long and is used with a swing-away flat press to decorate the item 984 sublimation spoon rest. The metal portion of the puck is 0.60" thick with a 0.125" thick silicon rubber sheet for a total thickness of 0.725". Pre-heat the puck in the press and then handle with gloves. When decorating the spoon rest, use heat tape to hold the transfer in the center of the rest, cover with a blank piece of paper and then place the puck (silicon rubber side down) on the center of the rest. Press at 400 degrees for 8 to 15 minutes. The time depends on how powerful your heat press is, as the heat has to travel through the aluminum puck to the transfer and spoon rest. If your image is too light, you likely need to press at a longer time, and if the image browns then you have pressed too long.

Availability: In stock